View Here : How To Install Equalizer To Amplifier
For optimum grounding, the grounding wire should be less than 20 inches and connected to the frame at any available bolt location in the trunk. Connect the speakers to the amplifier using standard speaker wire. Connect the equalizer patch cables to the stereo, and run them to the trunk. Use a wiring harness adapter.
Use cables long enough to allow you to place the equalizer in your rack. Connect the output of the equalizer to the preamp input of your integrated amplifier with the second pair of RCA cables. If you'll be connecting multiple components, you'll need an integrated amp with preamp out and in.
Basically, it is where the sound will be projected from after being intensified by the amplifier and “edited” by the equalizer. The three electronic devices (the amplifier, the equalizer and the receiver) go hand in hand for this process. There are different combinations to install your equalizer.
The amplifier should remain connected to the receiver with an RCA cable between the amplifier outputs and the amp inputs on the receiver. This effectively creates a loop from the receiver through the equalizer and amplifier and back to the receiver. Turn on the receiver, equalizer and amplifier to use your equalizer.
How to Install a Car Equalizer. Strip one end of 16 gauge wire and connect it to the EQ’s power input. Run the wire to the fuse panel and connect the wire with a fuse tap to the 12-volt power source. For the ground connection, you must undo a bolt or a screw that is near the EQ (or drill a hole to add one).
this is just an do it yourself vid on how to install an eq to your 4 channel amp hope it helps yall out.
Disconnect the battery earth lead. Find the live feed wire to the equalizer (it usually has an in-line fuseholder fitted). You can wire the equalizer to an ignition-controlled feed or, if it's more convenient, to the live feed of the radio-cassette unit. Finally, connect the unit to a good earth point.
Connecting an Equalizer to an Amp without a Receiver. Sometimes a receiver won't have the right output channels to connect the EQ to the amp. In this case, it's possible to connect the EQ directly to the amp. 1. Connect the RCA Cables. Connect two sets of RCA cables to from the EQ to the amp. Make sure they are the same cables and that they are long enough to stretch from the amp and the equalizer.
What you need to do is first connect the Zone 2 line outputs to the RCA inputs on the Technics DSP unit. Next, configure the settings in the Onkyo’s menu so that signals sent to the main zone are simultaneously output to Zone 2. With this setup, you won’t be able to utilize...
Need help installing DBX2015g equalizer, DBX120ds subharmonic synthesizer, and DBXdav600route selector, I have a Onkyo M-504 amplifier with one iput, Onkyo Preamplifier p304, with output,l line 1, line